This column outlines a step-by-step project to create a decorative feature on the back of your cabochons using small burrs that mount in a flex shaft. It involves using diamond ball burrs of various grits and homemade wood burrs.
The first step is to select a translucent area on your cab or slab that shows considerable transmission of light and color in the place where you will make the decorative feature. Mark a point with a felt tip pen and start the hole with a small coarse grit 1/8-inch diamond bur. I do the carving in a shallow plastic bowl cut from the bottom of a large plastic bottle with ½-inch of water inside. Dip the piece in the water and grind with the burrs for a few seconds and dip again.
Leggete l'articolo completo e molti altri in questo numero di
Rock&Gem Magazine
Opzioni di acquisto di seguito
Se il problema è vostro,
Accesso per leggere subito l'articolo completo.
Singolo numero digitale
Jul 2021
 
Questo numero e altri numeri arretrati non sono inclusi in un nuovo
abbonamento. Gli abbonamenti comprendono l'ultimo numero regolare e i nuovi numeri pubblicati durante l'abbonamento. Rock&Gem Magazine
Abbonamento digitale annuale
€33,99
fatturati annualmente
Abbonamento digitale di 6 mesi
€18,99
fatturati due volte l'anno
Abbonamento digitale mensile
€5,99
fatturati mensilmente