PROJECT 3
USE A PLAMP
WATCH VIDEO ONLINE http://bit.ly/pp_203_3
TIP 1 SET UP YOUR PLAMP
Wimberley’s The Plamp II is simple and effective, but it offers a high level of adjustability too, should you need it. On the large clamp end you can adjust the clamp’s spring tension with a screwdriver. While at the smaller ‘clip’ end you can adjust the force required to rotate the clip by removing the last ball joint from the arm (we found bending it back around on itself did the trick), you can then access a Torx 20 mounting screw which you can adjust with your included hex key to make it more stiff or loose. You then need to apply a good bit of pressure to get the clip end onto the arm again. If you struggle with this last step you can warm the female end in near-boiling water to expand it a little.